EZSync FTDI Chip Usb to RS232 Serial Adapter Cable, CNC Controls Programming Cable, 25 Pin DB25 Male Connector, 1.5m, FTDI UC-232R US-232R Compatible, full RS232 signals, EZsync014B

  • 1.5m(60 inches) industrial grade USB to RS232(DB25 Male) adapter cable. It is an ideal solution for computer to communicate with many serial devices directly through USB port such as CNC, PLC, plotter, modem, Scanner etc
  • This cable is designed to make connection between USB port and serial devices(RS232), NOT for parallel printer or other devices based on parallel protocol (IEEE-1284), even though both have DB25 connector. It is a USB to RS232 Serial cable can be configured as either XON/XOFF software handshaking or hardware handshaking(RTS/CTS or DSR/DTR). Check your devices setup prior to purchase.
  • Works with USB 1.1 & 2.0 Host and Hub ports. Powered directly by USB port, no external power adapter required. Industry Standard FTDI chip set & device drivers to ensure maximum compatibility and superior reliability for industrial application
  • Heavy duty metal DB25 connector with locking screws on one end, over-molded plastic USB housing on the other end of the cable
  • RS-232 data signals: TxD, RxD, RTS, CTS, DSR, DTR, DCD, RI, GND. Has access to all signal wires and the pin out is reconfigurable to meet the specific needs of your device.
SKU: EZSync014B Category:

Description

Every EZSync cable is built to last for years with high-quality industrial grade materials. EZsync014B is a USB to RS-232 full protocol interface adapter cable. No external power supply needed. Compatible with USB and RS-232 standards. EZsync014B is capable of performing the conversion from single-ended USB signal into UART signal of RS-232. DB25 male connector is used for connection from RS-232 interface. The unique I/O circuit of the internal zero delay auto transceiver contained in the converter controls the data stream direction automatically. The cable is plug-and-play for windows7, 8 and 10. This cable will work for computer USB to a CNC or other serial devices using XON/XOFF software handshaking or hardware handshaking(RTS/CTS or DSR/DTR). Most of the CNC controls are software based handshaking, this cable will work. Please contact the seller if you are not sure this cable works or not for your devices. Some examples: Acramtic Amanda Brother Bosch Boss DeltaDynaPath Fagor Haas Heidenhain Mazak Mori Mitsubishi based controls -all Sinumerik Yasnac Siemens and more.

Reviews

There are no reviews yet.

Be the first to review “EZSync FTDI Chip Usb to RS232 Serial Adapter Cable, CNC Controls Programming Cable, 25 Pin DB25 Male Connector, 1.5m, FTDI UC-232R US-232R Compatible, full RS232 signals, EZsync014B”

Your email address will not be published. Required fields are marked *

Related products